Mf-digital DIRECTOR EC OFFICE PUBLISHER WITH Spectrum2 PRINTE Manuel d'utilisateur télécharger pdf (Page 2)

Installing the Firewire Adapter & Software Identifier Cards

You should never attempt to service a unit without ensuring proper anti-static protection. The

use of a grounding strap, or other such grounding device, is advised. In addition, the internal

configuration of your computer may be different from the computer pictured below.

Note:

Installing the Firewire Card

The DirectorEC Office Publisher requires

one IEEE-1394 card.

1. Shut down the PC.

2. Turn the PC’s power off.

3. Unplug the PC.

4. Remove the PC’s cover as

indicated in the PC’s manual.

5. Locate an empty PCI slot, as

seen in (fig.1).

6. Install the firewire adapter card (fig. 2).

Installing the Software Identifier Card

a. If your PC is not OFF, perform the

Windows shutdown now.

b. Turn-off powers switch and unplug AC

power from the wall.

c. If the PC’s cover has been re-installed,

remove it now.

d. Locate an Empty slot, Mount the

Software Identifier card in slot as

illustrated (fig. 3).

e. Connect the 3.5” Floppy type power

cable such that the yellow wire is

facing out.

f. Using a 40 Pin EIDE cable, connect the

card to the Secondary IDE Channel on

your PC mother- board.

g. Be sure PIN 1(red wire) if facing

AWAY from the motherboard, and

next to the power connector on

software identifier card (fig. 3).

(fig. 3)

(fig. 1) (fig. 2)

Page 2

1 2 3 4 5 6 7 ... 13 14

Pas de commentaire

Mf-digital DIRECTOR EC OFFICE PUBLISHER WITH Spectrum2 PRINTE Manuel d'utilisateur Page 2