Mf-digital PicoJet Offset Guide Manuel d'utilisateur télécharger pdf

Understanding the Offset Center Feature

Purpose:

The Offset Center feature is used to “tweak” the positioning of your printed image on your disc so the image is

printed on center. This feature should not be used if you have not set your Mask Settings first. See the Mask

Settings Guide for instructions on how to set up the Mask Settings.

Getting Started

Before starting this procedure, please make a table like the sample one below.

Sample:

X Y

+1mm -1 mm

-1mm +1mm

This will aid you in the amount of steps (millimeters or 1/10mm) you have adjusted your Offset Center. Should you

over-adjust the X and Y coordinates, you will now know how many steps to adjust + or -.

This procedure should be used with the PicoJet

Alignment PRN.

The PRN can be found in the C:\Reserved for

Tech Support\Test Files\TEST PRNs\PicoJet

Located on the C Drive. (SA, PC, Director, and

Director Pro Systems only). EC Series Users can

download the PRN from www.mfdigital.com

website.

The outer diameter is set to 114MM

1 2 3

Understanding the Offset Center Feature Purpose: The Offset Center feature is used to “tweak” the positioning of your printed image on your disc so

Printing the Alignment Pattern To verify the printer’s current Alignment, first print the PicoJet Alignment Pattern PRN file and note the position o

Page 3

When entering the coordinates, it is best to do one at a time, first the X then the Y. The values can be entered as + or – value depending on the dir

Pas de commentaire

Mf-digital PicoJet Offset Guide Manuel d'utilisateur